SIST EN 60512-14-5:2006

SLOVENSKI SIST EN 60512-14-5:2006

STANDARD
oct 2006
Konektorji za elektronsko opremo – Preskusi in meritve – 14-5. del: Preskusi
tesnosti – Preskus 14e: Potapljanje pri nizkem zračnem tlaku (IEC 60512-14-
5:2006)
Connectors for electronic equipment – Tests and measurements – Part 14-5:
Sealing tests – Test 14e: Immersion at low air pressure (IEC 60512-14-5:2006)
ICS 31.220.10 Referenčna številka
©  Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno

EUROPEAN STANDARD
EN 60512-14-5
NORME EUROPÉENNE
May 2006
EUROPÄISCHE NORM
ICS 31.220.10
English version
Connectors for electronic equipment -
Tests and measurements
Part 14-5: Sealing tests -
Test 14e: Immersion at low air pressure
(IEC 60512-14-5:2006)
Connecteurs pour équipements Steckverbinder für elektronische
électroniques - Einrichtungen -
Essais et mesures Mess- und Prüfverfahren
Partie 14-5: Essais d'étanchéité - Teil 14-5: Prüfungen der Dichtheit -
Essai 14e: Immersion à basse pression
Prüfung 14e: Tauchen bei Unterdruck
atmosphérique (IEC 60512-14-5:2006)
(CEI 60512-14-5:2006)
This European Standard was approved by CENELEC on 2006-04-01. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Cyprus, the Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Central Secretariat: rue de Stassart 35, B - 1050 Brussels

© 2006 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60512-14-5:2006 E
Foreword
The text of document 48B/1607/FDIS, future edition 1 of IEC 60512-14-5, prepared by SC 48B,
Connectors, of IEC TC 48, Electromechanical components and mechanical structures for electronic
equipment, was submitted to the IEC-CENELEC parallel vote and was approved by CENELEC as
EN 60512-14-5 on 2006-04-01.
This standard is to be read in conjunction with EN 60512-1 and EN 60512-1-100 which explains the
structure of the EN 60512 series.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2007-01-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2009-04-01
Annex ZA has been added by CENELEC.

__________
Endorsement notice
The text of the International Standard IEC 60512-14-5:2006 was approved by CENELEC as a European
Standard without any modification.
__________
- 3 - EN 60512-14-5:2006
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications

The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.

NOTE  When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD
applies.
Publication Year Title EN/HD Year
1) 2)
IEC 60512-1-1 – Connectors for electronic equipment - Tests EN 60512-1-1 2002
and measurements
Part 1-1: General examination - Test 1a:
Visual examination
1) 2)
IEC 60512-3-1 – Connectors for electronic equipment - Tests EN 60512-3-1 2002
and measurements
Part 3-1: Insulation tests - Test 3a: Insulation
resistance
1) 2)
IEC 60512-4-1 – Connectors for electronic equipment - Tests EN 60512-4-1 2003
and measurements
Part 4-1: Voltage stress tests - Test 4a:
Voltage proof
1)
Undated reference.
2)
Valid edition at date of issue.

NORME CEI
INTERNATIONALE
IEC
60512-14-5
INTERNATIONAL
Première édition
STANDARD
First edition
2006-03
Connecteurs pour équipements électroniques –
Essais et mesures –
Partie 14-5:
Essais d'étanchéité –
Essai 14e: Immersion à basse pression
atmosphérique
Connectors for electronic equipment –
Tests and measurements –
Part 14-5:
Sealing tests –
Test 14e: Immersion at low air pressure
 IEC 2006 Droits de reproduction réservés  Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in any
utilisée sous quelque forme que ce soit et par aucun procédé, form or by any means, electronic or mechanical, including
électronique ou mécanique, y compris la photocopie et les photocopying and microfilm, without permission in writing from
microfilms, sans l'accord écrit de l'éditeur. the publisher.
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 00 E-mail: inmail@iec.ch Web: www.iec.ch
CODE PRIX
F
PRICE CODE
Commission Electrotechnique Internationale
International Electrotechnical Commission
МеждународнаяЭлектротехническаяКомиссия
Pour prix, voir catalogue en vigueur
For price, see current catalogue

60512-14-5  IEC:2006 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
CONNECTORS FOR ELECTRONIC EQUIPMENT –
TESTS AND MEASUREMENTS –
Part 14-5: Sealing tests –
Test 14e: Immersion at low air pressure

FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used
...